Important Safety Instructions - Craig CSH308 Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS

FCC Warnings
WARNING:Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the condition that this
device does not cause harmful interference (1) this
device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
‡
Reorient or relocate the receiving antenna.
‡
Increase the separation between the
equipment and receiver.
‡ Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
‡
Consult the dealer or an experienced radio/TV
technician for help.
The device has been evaluated to meet
general RF exposure requirement.
The device can be used in portable
exposure condition without restriction.
FCC ID:OKU-CSH308
FCC NOTICE:
To assure continued compliance, follow the attached
installation instructions and use only shielded cables
when connecting to other devices. Modifications not
authorized by the manufacturer may void user's
authority to operate this device.
2