Battery Replacement - Extech Instruments HT200 User Manual

BLACK GLOBE TEMPERATURE OFFSET
1. Step to the Black Globe Temperature Offset screen using the
screen shown above).
2. Press the
3. Use the up and down arrow buttons to set the offset value (from ‐9.9 to +9.9).
4. Press the
5. Press the
Battery Replacement
When the battery icon (
power and unplug all cables. Remove the battery from the rear battery compartment and
replace it with a new 9V battery. Please observe correct battery polarity and do not switch the
unit ON until the battery door is closed and secured.
When the meter is not in use, please remove the battery.
Disposal: Do not dispose of this instrument in household waste. The user is obligated to take
end‐of‐life devices to a designated collection point for the disposal of electrical and electronic
equipment.
AC Adaptor Power
The AC power adaptor jack is located on the bottom of the meter. See specifications below:
External AC to DC adapter: Voltage 9 V
Socket: Pin positive, Ground casing negative.
External diameter 5.5mm internal diameter 2.1mm
800.561.8187
button to begin editing; the display will begin flashing.
button to select the desired temperature units.
button again to save the setting.
appears on the LCD, the 9V battery must be replaced. Turn off the
)
Never dispose of used batteries or rechargeable batteries in household waste.
As consumers, users are legally required to take used batteries to appropriate
collection sites, the retail store where the batteries were purchased, or wherever
batteries are sold.
www.
(8~14 V Max) / 500mW.
DC DC
9
.com
EXTECH INSTRUMENTS
button (example
HT200‐en‐GB_V1.4 11/16
information@itm.com