ROHO Smart Check Operation Manual page 9

Smart Setup Instructions, Continued
5a.
5a. Press the Check  Button.
When you see the red down arrow  light,
proceed to step 5b.
5b.
5b. Press (but do not hold) the Setup Button.
The red down arrow  light will now flash.
Open the inflation valve, release air (approximately 30
to 60 seconds)*, and wait for the flashing green light.
If the red down arrow  light stops flashing before you
have opened the valve, go back to 5a.
*To ensure an accurate reading: Remain still and avoid
restricting air flow while you release air from the cushion.
Store Smart Check in a safe and accessible location. See d
Smart Check by ROHO Operation Manual
8
NOTE: If you see the red up arrow  light
when you press the Check Button:
1) Make sure the quick disconnect is securely
attached, and 2) Open the inflation valve,
add more air, close the inflation valve, and
press the Check  Button again. Repeat until
you see the red down arrow light.
When you see the flashing green
light, close the inflation valve. The
green light means that Setup is
complete.
Your cushion is now set up.
(Next: See C
heCk
s instructions.
isconnecTion and Torage
I .)
nstruCtIons