Optional Setup Instructions; Hand Check Guide - ROHO Smart Check Operation Manual

Optional Setup Instructions

Optional Setup is an alternative to Smart Setup that records your preferred cushion inflation setting. See o
Part One: Adjust Your Cushion Without Smart Check
1. Perform a Hard Reset. See h
NOTE: For first-time use, remove the battery pull tab.
2. Inflate the cushion and place it in the chair. Sit on the cushion
in your usual position. Adjust the cushion by following the c
instructions in the ROHO
Technology Operation Manual.
3. Perform a hand check to confirm immersion and envelopment. (See the h
c G in this manual.)
heck uIde
Part Two: Save your Setting with Smart Check
• It is recommended that a qualified seating specialist be consulted when saving a preferred cushion inflation setting
with Optional Setup.
• Perform the following steps in the usual environmental conditions.
Quick
Disconnect
4. Make sure Smart Check
is attached to your
cushion. You will hear
a "click" when the
connection is secure.
Store Smart Check in a safe and accessible location.
See d
isconnecTion and

Hand Check Guide

Use this guide to adjust your cushion during Optional Setup.
A hand check is also recommended after performing Smart Setup so you will have a
reference point if you need to adjust your cushion without Smart Check (for example, if
the device has been misplaced).
Before you perform a hand check, refer to i
the warning about using an under-inflated cushion or an over-inflated cushion.
1. Place your hand between yourself and the cushion. Feel for the lowest bony
prominence. You should be able to slightly move your fingertips. The recommended
distance between the individual and the seating surface is 1/2 - 1 inch (1.5 cm to 2.5 cm).
2.
If it feels like the cushion has too much air or not enough air, adjust as needed and see c
Smart Check by ROHO Operation Manual
r I .
ard eSet nStructIonS
Single Compartment Cushion with Sensor Ready
®
5. Make sure the inflation valve is
closed. Press the Check  Button
to activate Smart Check. You will
see either a  or a  red light.
DO NOT add or remove air.
s instructions.
Torage
mporTanT
a
uShIon djuStment
and
6. Press and hold the Setup Button for four (4)
seconds until you see a green light. The green
light means that your preferred cushion inflation
setting has been saved. The green light DOES
NOT indicate a Proper Cushion Inflation Setting.
See o
vervIew
Your cushion is now set up. (Next: See C
s i and read
afeTy nformaTion
10
for more information.
vervIew
Symbols and Lights for Optional Setup
Green Light
"Setup is complete."
™
4s
for more information.
heCk
1/2" - 1" (1.5 - 2.5 cm)
I and o
heck nStructIonS
Setup
Button
Check
Button
I .)
nstruCtIons
.
vervIew