Radio/Gps Unit Cable Terminations - 3M Opticom Installation Instructions Manual

14

5.3 Radio/GPS Unit Cable Terminations

1. Route the cables from the radio/GPS antenna
through the vehicle to the radio/GPS unit
location.
2. Coil up any excess cable.
Note: When coiling excess cable do not create
any sharp bends in the cable or the cable may
be damaged.
3. Connect the cable labeled GPS to the GPS
connector on the radio/GPS unit. Connect
the other cable to the Radio connector.
Tighten the connectors using a 5/16" wrench
(an 8 mm wrench may also be used)
Note: The connectors are keyed and cannot be
connected to the wrong connector.
4. Plug the 15 pin connector of the radio/GPS
cable (black cable) into the P1 connector of
the radio/GPS unit and tighten the screws.
3. Route the cable to the location where the
Vehicle Control unit will be installed.
1. Vehicle radio/GPS unit
2. Vehicle interface harness assembly
Vehicle Equipment Installation Instructions
Figure 5-3. Radio/GPS Cable Installation
Table 5-1. Radio/GPS Unit Terminal Block
Pin Index
Pin Wire Color
1 Yellow
2 Yellow Black
3 Blue
4 Blue White
5 Orange
6 Orange Green
7 Brown
8 Brown White
9 Violet
10 Violet White
11 Bare
3. GPS antenna cable
4. Radio antenna cable
Function
Radio transmit (+)
Radio transmit (–)
Radio receive (+)
Radio receive (–)
Radio clock (+)
Radio clock (–)
GPS power
Common
Radio power
Common
Shield drain wire