Interface Description - Dynacord P 64 Owner's Manual

3.3 Interface description

Ethernet Interface
By connecting the P 64 audio matrix via the Ethernet interface, the
communication between the P 64 and one or several PC is possible. This allows
the configuration of P 64 via IRIS-Net software. Furthermore, the whole
connected system (consisting of P 64s and DYNACORD Remote Control
Amplifiers) can be operated and monitored. By using appropriate network
hardware it is even possible to operate the P 64 via a wireless network (WLAN). The Ethernet
interface on the rear of P 64 is a RJ-45 connector (8P8C). Both 10Base-T and 100Base-TX
Ethernet standards are supported. The connections of the Ethernet interfaces can be seen in the
following figure and table.
Pin Name
1
2
3
6
The pin assignment of the Ethernet connector is shown in the following figure. The connector is
viewed from the contact side.
Pin Assignment of Ethernet jack
Description
Tx+ Transmit+
Tx- Transmit-
Rx+ Receive+
Rx- Receive-
Pin Assignment of Ethernet plug
Colour
Pair
T568A
Green striped
2
Green
Orange striped
3
Orange
Preparations
T568B
Orange striped
Orange
Green striped
Green
P 64 Digital Audio Matrix
Owner's manual
17