Hardware Installation - Fe9391-Ev - Vivotek FE9191 User Manual

Hardware Installation - FE9391-EV

Opening Dome Cover
1. Jot down the camera's MAC address for later reference. This is especially important if you in-
stall many cameras in your surveillance deployment.
Network Camera
Model No: XXXXXX
MAC: 0002D14BAD55
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Pat. 6,930,709 Made in Taiwan
2. Use the supplied screwdriver to loosen the four screws and detach the dome cover from the
camera base. Then, follow the steps below to install the camera to either a ceiling or a wall.
3. If edge recording is preferred, install a microSD card to the camera.
64
GB
10
1
I
Tamper-proof Screw
VIVOTEK
User's Manual - 17