Applications > Tampering Detection - Vivotek FE9191 User Manual

Applications > Tampering detection
This section explains how to set up camera tamper detection. With tamper detection, the
camera is capable of detecting incidents such as redirection, blocking or defocusing, or even
the spray paint.
Please follow the steps below to set up the camera tamper detection function:
1. Click to select the checkbox before tampering conditions: Tampering detection, Image too
dark, Image too bright, and Image too blurry. Enter the tamper trigger duration. (10 sec. ~ 10
min.). The duraction specifies the set of time before the tampering is considered as a real
alarm. This helps avoid false alarms by short-lived changes.
The tamper alarm will be triggered only when the tampering factor (the difference between
current frame and pre-saved background) exceeds the trigger threshold. Conditions such
as image too dark, too bright, or too blurry (defocused) can also be configured as tampering
conditions. The Trigger threshold determines how sensitive is your tamper detection setting.
Lower the threshold number, easier to trigger.
Too bright: shining a flash light. The average lighting level of the scene is taken into
consideration.
Too dark: covering the objective or spraying paint.
Too blurry: blurry scene can be the result of strong interference on the device, such as EMI
interference.
2. You can configure Tampering Detection as a trigger element to the proactive event
configurations in Event -> Event settings -> Trigger. For example, when the camera is
tampered with, camera can be configured to send the pre- and post-event video clips to a
networked storage device. Please refer to page 130 for detailed information.
VIVOTEK
User's Manual - 147