Canon EF70-200mm IS II USM Instructions Manual page 2

Thank you for purchasing a Canon product.
Dedicated to EOS cameras, the Canon EF70-
200mm f/2.8L IS II USM lens is a high-
performance telephoto zoom lens equipped
with an Image Stabilizer.
• "IS" stands for Image Stabilizer.
• "USM" stands for Ultrasonic Motor.
" •• Warning to prevent lens or camera malfunction
~ or damage.
1=¥1
Supplementary notes on using the lens and
LjI
taking pictures.
Features
1. The Image Stabilizer gives the equivalent
effect of a shutter speed four stops faster*.
2. With fluorite and UD lens elements,
outstanding image delineation is obtained
3. Ultrasonic motor (USM) for quick and quiet
autofocusing.
4. Manual focusing is available after the subject
comes into focus in autofocus mode (ONE
SHOT AF).
5. A truly round aperture hole results in a nicer
background blur.
6. The lens is compatible with Extender EF1.4X
and EF2X II.
7. Tight seal structure ensures excellent dust-
proof and drip-proof performance.
Based on [1/focallength] second. Generally, it requires
*
a shutter speed [1/focallength] second or faster to
prevent camera shake.
6
Safety Precautions
• Do not look at the sun or a bright
through the lens or camera. Doing
in loss of vision. Looking at the sun
the lens is especially hazardous.
• Whether it is attached to the camera
not leave the lens under the sun without
lens cap attached. This is to prevent
.
concentrating the sun's rays, which could
fire
Handling Cautions
• If the lens is taken from a cold environment
a warm one, condensation may develop
lens surface and internal parts. To prevent
condensation in this case, first put the lens into an
II
airtight plastic bag before taking it from a cold to
warm environment. Then take out the lens
has warmed gradually. Do the same when taking
the lens from a warm environment into a cold
• Do not leave the lens in excessive heat
a car in direct sunlight. High temperatures
cause the lens to malfunction.
This device complies with Part 15 of the FCC
subject to the following two conditions:
cause harmful interference, and (2)
light source
interierence received, including interference
so could result
undesired operation.
directly through
not
00 make any changes or modifications
unless otherwise specified in the instructions.
or not, do
modifications should be made, you could be required
the
operation of the equipment.
the lens from This equipment has been tested and found to comply
cause a limits for a class B digital device,
Rules. These limits are designed
against harmful interference in a
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
instructions, may cause harmful interference
into
communications.
on the
However, there is no guarantee that interference
a particular installation. If this equipment
interference to radio or television
determined by turning the equipment
after it encouraged to try to correct the interference
the following measures:
• Reorient or relocate the receiving
one.
• Increase the separation between
such as in
• Consult the dealer or an experienced
can
help.
This Class B digital apparatus complies
Rules. Operation is
(1) This device may not
this device must accept any
that may cause
to the equipment
If such changes or
to stop
with the
pursuant to part 15 of the FCC
to provide reasonable protection
residential installation. This
with the
to radio
will not occur in
does cause harmful
reception, which can be
off and on, the user is
by one or more of
antenna.
the equipment and receiver.
radiolTV technician for
with Canadian ICES-003.