Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Canon LEF7020028CA
Summary of Contents for Canon LEF7020028CA
- Page 1 EF70-200mm f/2.8L IS II USM Instruction...
- Page 2 Thank you for purchasing a Canon product. Dedicated to EOS cameras, the Canon EF70- Features 200mm f/2.8L IS II USM lens is a high- 1. The Image Stabilizer gives the equivalent performance telephoto zoom lens equipped effect of a shutter speed four stops faster*.
- Page 3 a Safety Precautions This device complies with Part 15 of the FCC Rules. Operation is a Safety Precautions subject to the following two conditions: (1) This device may not • Do not look at the sun or a bright light source cause harmful interference, and (2) this device must accept any interference received, including interference that may cause through the lens or camera.
- Page 4 Nomenclature Focusing distance range selection switch (→ 5) Distance scale (→ 11) Hood mount (→ 7) Zoom ring (→ 6) Rubber ring (→ 4) Filter mounting thread (→ 13) Contacts (→ 4) Focusing ring (→ 5) Lens mount index (→ 4) Focus mode switch (→...
-
Page 5: Mounting And Detaching The Lens
If the rubber ring becomes worn, it is replaceable by a Canon Service Center at cost. • After detaching the lens, place the lens with the rear end up to prevent the lens surface and electrical contacts from getting scratched. -
Page 6: Setting The Focus Mode
2. Setting the Focus 3. Switching the Focusing Mode Distance Range To shoot in autofocus (AF) mode, set the focus You can set the focusing distance range to mode switch to AF. 1.2 m/3.9 ft. to infinity or 2.5 m/8.2 ft. to infinity. To use only manual focusing (MF), set the focus By setting the suitable focusing distance range, mode switch to MF, and focus by turning the... - Page 7 4. Zooming To zoom, turn the zoom ring. Be sure to finish zooming before focusing. Zooming after focusing can affect the focus. ENG-6...
- Page 8 5. Hood The ET-87 hood can keep unwanted light out of the lens, and also protects the front of the lens from rain, snow, and dust. Button Attaching Removing To attach the hood, align the hood’s attachment To remove the hood, hold down the button on the position mark with the red dot on the front of the side and turn the hood in the direction of the lens, then turn the hood as shown by the arrow...
-
Page 9: Image Stabilizer Settings
6. Image Stabilizer Settings You can use the image stabilizer in AF or MF mode. Set the STABILIZER switch Select the stabilizer mode. When you press the shutter button halfway, the Image • MODE 1: Corrects vibrations Stabilizer will start in all directions. -
Page 10: Tips On Using The Image Stabilizer
7. Tips on Using the Image Stabilizer The image stabilizer in this lens is effective for hand-held shots under the following conditions. ● MODE 1 ● MODE 2 • In semi-darkened areas such as indoors or • When panning subjects in motion. outdoors at night. - Page 11 Tips on Using the Image Stabilizer • Using a tripod also stabilizes the image. • The Image Stabilizer cannot compensate for a However, depending on the kind of tripod and blurred shot caused by a subject that moved. shooting conditions, sometimes it may be better •...
-
Page 12: Infrared Index
8. Infinity Compensation Mark 9. Infrared Index Infinity compensation mark Distance index To compensate for shifting of the infinity focus The infrared index corrects the focus setting when using point that results from changes in temperature. monochrome infrared film. Focus on the subject The infinity position at normal temperature is the manually, then adjust the distance setting by moving the point at which the vertical line of the L mark is... -
Page 13: Using The Tripod Mount
10. Using the Tripod Mount Adjusting the Revolving Mount You can loosen the orientation lock-knob on the tripod mount to allow it to rotate as needed to fit a particular camera model for switching between vertical and horizontal positions. Detaching First remove the lens from the camera and then remove the tripod mount from the lens as shown below. -
Page 14: Close-Up Lenses
You can attach Extension Tube EF12 II or EF25 II for magnified shots. The shooting distance and • If you need a polarizing filter, use the Canon magnification are shown below. Circular Polarizing Filter (77mm). - Page 15 14. Extenders (Sold separately) With Extender EF1.4X ll or EF2X ll attached, the lens specifications will change as follows: Item With EF1.4X ll Extender With EF2X ll Extender Focal length (mm) 98 – 280 140 – 400 Aperture f/4 – 45 f/5.6 –...
-
Page 16: Specifications
• The size and weight listed are for the lens only, except as indicated. • Aperture settings are specified on the camera. • All data listed is measured according to Canon standards. • Product specifications and appearance are subject to change without notice. - Page 17 CT1-7586-002 © CANON INC. 2010 2010.2...