ICPDAS HRT-710 User Manual page 34

MB_Addr
(HEX)
1F4
1F4
1F5
1F5
1F6
1F6
1F7~1F9
1FA~76B
76C
76C
76D
76E~7FB
[ Note ]
(1) MB=Modbus, CMD=Command, MOD=Module, DEV=Device
(2) 500L: The low byte of MB_Addr 500.
500H: The high byte of MB_Addr 500
(3) Default CMD(num)(format):
[1] Num: means HART command number. When add a new HART device in module, these
two default commands – "Default CMD(0)" and "Default CMD(3)" will be produced
automatically.
[2] Format: means the format of HART command of HRT-7(3)10.
<1> Normal format (N): Use the standard HART command format.
<2> Simple format (S): Refer to "Appendix B: Command Format".
(4) The description of the "Default CMD(0 & 3)" status:
It consists of two bytes. The first byte is the state of "Default CMD(0)" and the second byte is
the state of "Default CMD(3)".
Ex: If the value is 0x0100 for the MB address 1000, then the 1000L is 0x00 and the 1000H is
0x01. It means the error status of "Default CMD(0)" is 0x00 and the error status of "Default
CMD(3)" is 0x01 in "Module 0".
HRT-710 / HRT-310 User Manual
Copyright © 2017 ICP DAS Co., Ltd. All Rights Reserved
OUTPUT DATA
MB_Addr
(Decimal)
500L Auto Polling function
500H Reserved
501L Reset module state function
501H Reserved
502L Output Trigger function
502H The index of trigger command
503~505 Reserved
506~1899 Reserved (For Module Configuration)
1900L Channel selection in through mode
1900H Reserved
1901 Send data length in through mode
1902~2043 Send data in through mode
Description
Version 1.31
E-mail: service@icpdas.com
34
Page：