NETGEAR CG3000D Instructions Manual page 2


Connect to the BendBroadband cable network and download the latest configuration files.
This can take up to 15 minutes to complete.

Obtain an IP address for the gateway. Then the gateway assigns an IP address for the
connected PC.

Connect to the Internet.
4. Wait for the LED lights to stop blinking (as noted above this could take up to 15 minutes when the
Gateway is first powered on). Then verify the following:
The Power LED is solid green.
The Downstream and Upstream LEDs are lit.
The Internet LED is solid green, indicating a link has been established to the Internet.
The LAN LED is lit that corresponds to the local Ethernet port where you connected your
computer.
For more information, see the LED table below.
2