DèLonghi TA60SS User Manual page 10

Installing your Rangehood
Installation Method
The rangehood is designed to be installed in
either Extraction Method or Re-Circulating
Method (Requires purchase of Carbon Filters
sold separately).
Extraction Installation Method
Ÿ
The air is vented outdoors by a duct which
must be connected to exhaust hole
Ø120mm using the connecting ring (A).
Ÿ
The hood must not be connected to fuel
exhaust flues or to a duct in which hot air is
circulated, or is utilised to remove the fumes
from appliances stocked by an energy
different from the electric one.
Ÿ
The air must not be discharged into a flue
that is used for exhausting fumes from
appliances burning gas or other fuels.
Ÿ
For correct functioning, provide suitable
ventilation of the room using doors,
windows or other technical devices.
Page 10
Re-circulation Installation Method
The Rangehood can only be installed in this
method with the purchase of Carbon Filters
that are sold as an optional accessory.
Ÿ
When there is no exhaust duct for venting
outdoors, you can use a carbon filter (D). The
cooking fumes are filtered and then pushed
back out again.
Ÿ
Filters are not washable; they cannot be
regenerated and have to be replaced at
most every 2 months.
Ÿ
The saturation of the activated charcoal
depends on the frequency of use of the
hood, on the type of cooking and on the
regularity of cleaning the grease filter.
Ÿ
The carbon filter has to be fitted inside the
hood. Push it into place until the stop click is
heard to lock it.
Ÿ
Remove the grill (E) see figure 2 to carry out
this operation.
Ÿ
The air is released in the room through a
connecting pipe, which goes through the
hanging cupboard and is connected to the
connecting ring supplied (A) see figure 1.
To use the appliance in this method, proceed as
follows:
- Open the grids (E)
- Insert the filter (D) with the knob (B).
- Reinstall the grids.