Icom IC-A200 Instruction Manual page 6

I ____ _ _, _ _ _ __ _
I 2 FREQUENCY SELECTION
—§
I Frequency selection I STBY window frequency
methods
There are 2 ways to select a desired frequency.
General frequency selection
Select a desired frequency which is used for the next
operating frequency in the STBY window. Then, ex-
change the USE window frequency for the STBY window
frequency.
Refer to STBY window frequency selection at right and
frequency exchanging. (p. 4)
Direct frequency selection
Select a desired frequency in the USE window directly.
Refer to USE window frequency selection. (p. 4)
selection
CAUTION: DO NOT turn the power ON until the
aircraft engines have been started. This is important for
protection of the circuits.
'CONVENIENT: For quick frequency selection, often-
used frequencies can be programmed into memory
channels. Refer to memory operation. (pgs. 7~10)
When a memoiy channel is recalled, the previous STBY
window frequency is erased.
1) Rotate the volume control clockwise to turn the power
ON.
v Previously used frequencies appear in the USE and
STBY windows.
2) Rotate the large and small tuning knobs to select a
desired frequency.
0 The USE window frequency is not affected.
~To change the 1 MHz digit, use the large tuning
knob. The small tuning knob does not change the
1 MHz digit.
"O"O -.;. 0/~.;;__ 1; ._ \
ll 'I: - "I" . 1:' -
I'-"I,-"I I'|""l" //1;' 'll 423:;-.
III.' I; ,,/- 'I lg. , 1/, I.' /-"0-, -
I II 'I /11 ' I 'll.' / "' I 0": "1'
I. I| '§ 1, I I| I| /II Q 70,0,
u. I. I , 1, I. l|| 'j 1,, | lg 0,
\.\\\-:1 "I: '\:'I|' 7- ii,' \ 'I:'ll;'
* ~' ~ \.-_\ . ll' ".\_'-'.4 gu ' t :g-flu
. . _ , _ ~~\\ F 5, . 'aka:
\\'\\
25 kHz steps 50 kHz steps 1 MHz steps
I _ ~
-
~
when pulled OUT. when pushed IN. I