Cv Programming - Märklin 24802 Manual

CV Programming

CV programming must be done on the programming track.
We recommend creating a fictitious locomotive for pro-
gramming purposes. Values in parentheses are the factory
settings.
The turnout lantern connected to the digital installation
decoder will blink as a control check during the data trans-
mission. The programming can be done optionally with fx
(MM) or DCC. In fx (MM), we recommend setting the address
by means of DIP switches (see 30ff).
fx (MM) / Motorola
Before doing any programming, the turnout to be program-
med must be switched with the Keyboard. After that, the CVs
can be changed as desired immediately with the Control Unit
or the CV configuration on the Central Station. Immediately
after that, switch the newly programmed turnout again with
the Keyboard. At this point the programming is accepted and
is functional.
CV Meaning
8 Decoder reset
36 Turnout lantern
off/on
The procedure for programming with the 6021 Control Unit is
the same as locomotive programming (www.maerklin.de ->
Service -> Technische Informationen).
Values
8 (-) factory setting, not
written value is
0-1 (1)
DCC
CV Meaning
1 Address, lower value
Byte
7 Manufacturer version
number (software
version)
8 Manufacture recogniti-
on ID Decoder reset
9 Address, higher value
Byte
29 Configuration
Bits 0-4 are not used
Bit 5: Decoder type
Bit 6: Addressing
method
Bit 7: Decoder type
36 Turnout lantern, off/on 0-1
Setting and generating addresses larger than 255:
Example: Address 1044 -> 1044:256=4,078125 . The value
before the comma (4) is to be entered in CV 9. The value after
the comma (0,078125) is multiplied by 256, 078125x256=20.
The value of 20 that is generated must be entered in CV 1.
Values
0-255
(-) read only
(131) read only,
8 (-) factory setting, value
is not written
0-7 (0)
(192) read only
0
0 / 32 basic or advanced
accessory decoder
decoder or output
0 / 64
address
128 accessory decoder
(1)
9