Advertisement
MULTIZONE CONTROLLER-KP (KEYPAD) INSTALLATION INSTRUCTIONS
IMPORTANT: The Multizone Controller-KP (keypad) should be mounted in an electrical box or in-wall mud ring using a screwdriver to
tighten. Do not use a power drill to tighten the keypad screws. Over tightening will damage the keypad.
INSTALLATION: Connecting the Multizone Controller-KP (keypads)
Use a good quality Cat5e/6 cable and crimp RJ45 jacks on each end of the cables. The RJ45 jack plugs into the back panel of the
keypads and the 6 x RJ45 jacks on the back panel of the Multizone Controller-Keypad-Hub. The Multizone Controller-KeypadHub is
included in your Multizone Controller kit. Plug the RJ45 jacks into any available jack on the Multizone Controller-Keypad Hub. Zone
assignment is determined by the MODE dip switches on the back of the Multizone Controller-KP (keypad).
8
Advertisement
