Advertisement
INSTALLATION — SPEAKERS
INSTALLATION: Connecting 8 ohm speakers to the system in BRIDGE MODE
In BRIDGE mode the amplifier LEFT and RIGHT outputs are combined into one large MONO amplifier, thus doubling the output
power to 50 watts with a minimum speaker load of 8 ohms.
Remove approximately 5 inches from the cable jacket, strip 1/4" of insulation from the speaker wire, and twist the copper strands.
Insert the speaker wires into the connector per the label below the output terminals and tighten the set screws. Repeat for the
remaining zones.
It is permissible to mix STEREO and Bridged MONO outputs on one unit.
Set the MODE switch
MO
NO
to BRIDGE
- +
8 ohm
speaker
10
Advertisement
