Yamaha YFM250BT 2004 Supplementary Service Manual page 13

È Do not route the handlebar switch assembly
lead through the lower bracket cable guide.
É Fasten the front brake light switch lead to the
handlebar with the plastic band.
Ê Faster the front brake light switch lead and front
brake hose to the handlebar with the plastic
band.
Ë Route the fuel tank breather hose through the
hole in the handlebar cover and then to the right
of the handlebar (below the handlebar, not over
it). Then, pass the hose through the cable guide.
CABLE ROUTING
Ì Fasten the handlebar switch assembly lead, rear
brake light switch lead, and starter cable to the
handlebar with the plastic bands.
Í Fasten the handlebar switch assembly lead to
the handlebar with the plastic band.
Î Fasten the rear brake light switch lead, front
brake light switch lead, and handlebar switch
assembly lead with the plastic band.
Ï Fasten the headlight leads to the frame with the
clamp.
– 6 –
SPEC