Advertisement
5. After securing the sub-base module, snap the SLATE module
into place and secure the module to the sub-base using
screws (included with SLATE module).
Wiring
WARNING
Electrical Shock Hazard.
Can cause severe injury, death or equipment damage.
1. Disconnect the power supply before beginning installation to
prevent electrical shock and equipment damage. More than
one power supply disconnect can be involved.
2. Wiring must comply with all applicable codes, ordinances and
regulations. See Fig. 2.
3. Wiring must comply with NEC Class 1 (Line Voltage) wiring.
Application
Communication
Lines
Other terminals
Table 2. Recommended Wire Sizes and Part Numbers.
IMPORTANT
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with these
instructions, may cause interference for radio communications.
It has been tested and found to comply with the limits of a Class
A computing device of part 15 of FCC rules, which are designed
to provide reasonable protection against such interference
SLATE
Sub-Base Module
™
R8001S9001
Recommended Wire
Size
22 AWG two-wire
twisted pair with
ground, or five-wire.
18 AWG wire insulat-
ed for voltages and
temperatures for given
application.
Recommended
Part Numbers
Belden 8723
shielded cable
or equivalent.
TTW60C,
THW75C,
THHN90C
9
Advertisement
