Advertisement
Quick Links
Advertisement
Related Manuals for STAR TRAC FITNESS S-TRx
Summary of Contents for STAR TRAC FITNESS S-TRx
- Page 1 Star Trac Fitness™ S-TRx Treadmill S-TRc Treadmill I n s t a l l G u i d e...
-
Page 2: Tools Required
SSEMBLY AND ETUP Use the following procedures to unpack and assemble your STAR TRAC S SERIES TREADMILL. Assembly procedures are the same for all S SERIES TREADMILLS. UNPACKING Open the shipping carton, remove all parts from the carton and foam inserts, and verify that the following parts are included in your shipment: Main Subassemblies Description Hardware Kit Description... -
Page 3: Install The Display Console
2. Install the Neck 5/16-18 x 1 3/4” Socket Head Bolts 5/16 Lock Washers 5/16 Flat Washers Locate the neck assembly (Qty. 1) and neck grommet (Qty 1) with console cables pre-installed inside. Remove packing material and slide the neck grommet over the neck. Position the neck in place on the motor end of the base assembly and secure with four 5/16"-18 x 2.0"... - Page 4 Note: - The S-TRx models only has the main interface ribbon cable, there is no DC power cable on these units. - MCB connector location of S-TRx and S-TRc are different, but the connecting procedure is the same. The...
- Page 5 6. Install Rear Console Top and Bottom Shrouds M4x19mm, Pan Head Screw Secure rear console bottom shroud to console in the correct position with six M4 x 0.7 x 19mm, Pan Head Screws, then secure console top rear shroud to console in correct position with eight M4 x 0.7 x 19mm, Pan Head Screws, tighten all screws securely.
- Page 6 8. Install Motor Top Cover #10-16 x 1/2" Pan Head Screws Remove the paper layer of the adhesive tape located on the back of the motor top cover, secure the front end of the cover to base assembly with two #10-16 x 1/2" tapping pan head screws, then secure the back end of cover to base assembly with two #10-16 x 1/2"...
- Page 7 10. Final Assembly Check the secure all of the hardware installed during assembly, and tighten as necessary. If necessary, level the treadmill using the two adjustable feet under the tailroller (at the rear of the base assembly). Loosen the locknuts, rotate the feet until the treadmill is stabilized, then retighten the locknuts. You have now completed assembly of your STAR TRAC S SERIES TREADMILL.