Connecting Using An S-Video Output; Connecting For Surround Sound - Pioneer Elite BDP-94HD Operating Instructions Manual

Connecting up

Connecting using an S-Video output

You can use the S-Video output instead of the VIDEO OUT jack to
connect this player to your TV (or other equipment).
• Use an S-Video cable (not supplied) to connect the S-VIDEO
OUT to an S-Video input on your TV, monitor or AV receiver.
Line up the small triangle above the jack with the same mark on the
plug before plugging in.
TV
CONTROL
IN
IR
IN
VIDEO OUT
SETTING 2
HDMI OUT LAN(10/100)
SETTING 1
S
IR RECEIVER
COMPONENT
VIDEO OUT

Connecting for surround sound

This player offers both analog and digital connections for surround
sound. The digital outputs (coaxial and optical) provide a convenient
way to connect this player to an AV receiver with built-in Dolby
Digital and/or DTS decoders. The 5.1ch analog outputs can be used
to connect to an AV receiver with multi-channel analog audio inputs.
Check the operating instructions that came with your AV receiver for
more on these connections.
Digital connections
• Connect one of the DIGITAL AUDIO OUT jacks on this player
to a digital input on your AV receiver.
AV receiver
CONTROL
IN
IR
IN
VIDEO OUT
SETTING 2
HDMI OUT LAN(10/100)
SETTING 1
S
IR RECEIVER
COMPONENT
VIDEO OUT
S-VIDEO
IN
AUDIO OUT AUDIO OUT
(5.1ch) (2ch)
Y
CENTER SURROUND FRONT
L L
DIGITAL AUDIO OUT
P
B
R
P
R
R
SUB WOOFER
COAXIAL OPTICAL
DIGITAL
AUDIO IN
COAXIAL
OPTICAL
AUDIO OUT AUDIO OUT
(5.1ch) (2ch)
Y
CENTER SURROUND FRONT
L L
DIGITAL AUDIO OUT
P
B
R
P
R
R
SUB WOOFER
COAXIAL OPTICAL
Optical connection: Use an optical cable (not supplied) to connect
the DIGITAL AUDIO OUT – OPTICAL jack to an optical input on
your AV receiver.
• When inserting the plug, the protective shutter will open and
you should hear the plug click into position when fully inserted.
Take care not to force the plug as this may damage the shutter,
the cable and/or the player.
Coaxial connection: Use a coaxial cable (not supplied) to connect
the DIGITAL AUDIO OUT – COAXIAL jack to a coaxial input on your
AV receiver.
Note
• Linear PCM audio output over the DIGITAL AUDIO OUT jacks is
limited to 2ch, 48 kHz.
Analog connections
• Connect the AUDIO OUT (5.1ch) jacks on this player to the
multi-channel analog inputs on your AV receiver.
Use a dedicated six-way cable (not supplied), or three sets of stereo
cables (not supplied) to connect the six channels.
Check carefully that each channel is connected to its corresponding
channel on the AV receiver.
After connecting, you can make settings for the number of speakers
connected to your system — see the Speakers section of the Initial
Setup menu on page 43 and Speaker Setup on page 45.
AV receiver
CONTROL
IN
IR
Y
IN
VIDEO OUT
DIGITAL AUDIO OUT
P
SETTING 2 B
HDMI OUT LAN(10/100)
SETTING 1
S P
IR RECEIVER R
COMPONENT
COAXIAL
VIDEO OUT
AUDIO IN
(5.1ch)
CENTER SURROUND FRONT
L
R
SUB WOOFER
AUDIO OUT AUDIO OUT
(5.1ch) (2ch)
CENTER SURROUND FRONT
L L
R
R
SUB WOOFER
OPTICAL
02
15
En