FUTABA 4YWD Instruction Manual page 11

Receiver R214GF-E
LED Link Switch
Connectors
●
WARNING
Keep the receiver as far away from the motor, ESC and other noise sources as
possible.
E.S.C. MC231CR
Checker LED
Pushbutton
switch
MC231CR
Power switch
● Built-in antenna
T h e R 2 1 4 G F - E
r e c e i v e r i s
d e s i g n e d t o b e
used only for EP
Car models.
Applicable motors
•Use the MC231CR with a motor with 23T or more turns.
*If a motor with a number of turns smaller than the above is used, the heat
protector and overcurrent protection circuit may operate. The number of turns
of the motor is only one criteria. Depending on the running conditions, the
protection circuit may operate even if the condition above is satisfied.
(Orange)
(Blue)
(Black)
(Red)
Receiver connector
Connects to the receiver throttle channel.
Servo S3003
to Receiver
Servo Horn
(Number of turns is criteria.)
Motor connector
Connects to the motor.
(Orange) is positive. (Blue) is negative.
If the motor rotates in the wrong
direction, interchange the connections of
this connector.
NiCd/NiMH battery connector
Connects to the running NiCd/NiMH battery.
(Red) is positive. (Black) is negative.
NiCd/NiMH battery 6~7 cells (7.2~8.4V)
Miniature screwdriver
Accessory. Use to press the
pushbutton switch.
Mounting
Flange
11