Full Pinout (Pins 8-14) - Lumenier DLUX OSD User Manual

Full Pinout (Pins 8-14)

8. ​ U 3 TX (USART) ​ ​ ​
- The DLUX can use this as an alternative way communicate information and
sends request to the RX on the flight controller or an alternate RX on another source like a
GPS.
9. ​ ​ U 3 RX (USART) ​ ​
- An alternative connection to receive telemetry information from a TX on
flight controller or alternate RX on another source like a GPS.
10. ​ ​ B attery Power In ​ ​ - The DLUX will need to receive power from the battery. This can be
connected to a battery directly or to a PDB (Power distribution Board). Voltage in range 7.4V -
18.5V (2S - 5S Lipo)
11. ​ B attery Ground In ​ ​ ​ - The DLUX will need to receive a ground connection from the battery.
This can be connected to a battery directly or to a PDB (Power distribution Board).
12. ​ G round ​ ​ ​ - Use this to provide a ground connection to the VTX (Video Transmitter).
13. ​ P ower Out for VTX ​ ​ ​
set to 5V, 12V, or Raw power from the battery. See the Power Logic & Configuration section for
details.
14. ​ V ideo Signal Out for VTX ​ ​ ​
Screen Display) comes from here and connects to the VTX (Video Transmitter).
- This is an adjustable power for the VTX (Video Transmitter). Can be
- The video signal with the telemetry info embed as OSD (On
3