Full Pinout (Pins 1-7) - Lumenier DLUX OSD User Manual

Full Pinout (Pins 1-7)

1. ​ U 1 TX (USART) ​ ​ ​ - The DLUX communicates information and sends request to the RX on the
flight controller.
2. ​ ​ U 1 RX (USART) ​ ​ - The telemetry information comes in from the TX on the flight controller.
3. ​ 5 Volts out Power ​ ​ ​ - This can be used as an option to power a flight controller.
4. ​ G round ​ ​ ​
- This can be used as an option to ground a flight controller.
5. ​ ​ G round ​ ​
- Use this to provide a ground connection to the camera.
6. ​ P ower Out for Camera ​ ​ ​
or Raw power from the battery. See the Power Logic & Configuration section for details.
7. ​ V ideo Signal In ​ ​ ​
- The Video signal from the camera connects to here. This is where OSD
information is embedded into the video.
- This is an adjustable power for the camera. Can be set to 5V, 12V,
2