Table of Contents
Advertisement
8
www.electrolux.com
The function switches off by
selecting a different fridge set
temperature.
3.10 EcoMode
For optimal food storage select the
EcoMode.
1. To switch on the function press Mode
until the corresponding icon appears.
After a few seconds the EcoMode
indicator goes on.
The temperature indicator shows the set
temperature:
• for the fridge: +4°C.
2. To switch off the function press Mode
in order to select an other function or
press the Mode until you can see
none of the special icons.
After a few seconds the EcoMode
indicator goes off.
The function switches off by
selecting a different set
temperature.
3.11 Door open alarm
An acoustic alarm will sound if the door is
left open for a few minutes. The door open
alarm conditions are indicated by:
• a flashing Alarm indicator;
• an acoustic buzzer.
When normal conditions are restored
(door closed), the alarm will stop. The
buzzer can also be switched off by
pressing any button.
3.12 Selecting and dispensing
water
Before dispensing water, select either still
cold water, low sparkling water or high
sparkling water.
The actual choice is indicated by the
indicator.
1. Water is dispensed by pressing a
glass or other container towards the
flap.
2. Draw back the glass or container to
stop the water flow and the indicator
goes off after a few seconds.
Any water that drips or is spilled is
collected in the drip tray below the
water dispenser. The drip tray can be
detached and emptied when
necessary.
3.13 Lighting
The water dispenser lighting illuminates
automatically when water is dispensed.
3.14 For continuous lighting
Make sure that the ice dispenser is
unlocked.
Press the Light button and the lighting
goes on.
Brightness is now about 20% until the
dispenser is used.
3.15 Switch off the lighting
Press the light button and the lighting
goes out.
3.16 Water filter indicator
1. When the water filter indicator lights
up the water filter has about 20%
remaining lifetime.
In this situation, it is recommended
that you buy a replacement filter.
2. When the water filter indicator starts
flashing, the water filter lifetime is
consumed . Replace the water filter
without delay, refer to "Installation of
the water filter".
3. When the water filter is replaced.
a. Press the filter reset button for 3
seconds to reset the water filter
indicator.
3.17 Water circuit cleaning
1. If you need to clean the water system
press Mode until the corresponding
icon appears.
After a few seconds the still cold water
indicator goes on.
Water select locked into still cold water.
2. Dispensing water in total 2 minutes.
The water system is cleaned.
The water circuit cleaning and the still cold
water indicator goes off.
3. To switch off the function before its
automatic end press Mode until the
corresponding icon appears.
Advertisement
Table of Contents
