Table of Contents
Advertisement
14
www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the Shopping-
Mode, or after changing the
temperature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The ShoppingMode func-
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
There is not enough carbon
dioxide in the water.
Possible cause
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The ShoppingMode func-
tion is switched on.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
tion is switched on.
The appliance is in dem-
onstration mode.
The appliance is not level-
led.
The carbon dioxide is run-
ning out.
The incoming water pres-
sure is too low.
Solution
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "ShoppingMode
function".
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off ShoppingMode
manually, or wait until the
function resets automatically
to set the temperature. Refer
to " ShoppingMode function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Refer to "Levelling".
Refer to "Installation of the
gas cylinder".
Drain off a large amount of
carbonated water (about 1 li-
tre).
Advertisement
Table of Contents
