Advertisement
3.1.20 Removing the spindle motor assembly
(See Figs.27 and 28)
• Remove the top cover, base board, chassis unit and clamper
assembly.
(1) From the top side of the chassis unit, turn the turn table
from side to side and remove the two screws M attaching
the spindle motor assembly through the hole of the turn ta-
ble. (See Fig.27.)
(2) From the bottom side of the chassis unit, turn the change
gear 2 in the direction of the arrow 2 while pulling the trigger
arm in the direction of the arrow 1 and let the pickup move
in the direction of the arrow 3. (See Fig.28.)
(3) Slide the spindle motor assembly in the direction of the ar-
row and take out it in an upward direction from the chassis
unit. (See Fig.28.)
Reference:
Remove the wires from the soldered sections c' on the base
board and remove them from the sections (d', e') on the chas-
sis unit as required.
1-18 (No.MY008)
M
Chassis unit
Fig.27
Spindle motor assembly
Wire(red)
d'
Wire(black)
c'
3
Base board
Pickup
Chassis unit
Fig.28
Turn table
Change gear 2
e'
2
1
Trigger arm
Advertisement
