Download Print this page

JVC TN2007-1026 Service Manual page 7

Cd mechanism

Advertisement

3.1.2 Removing the push switch
(See Figs.3)
(1) From the bottom side of the CD mechanism assembly, re-
move the screw B attaching the push switch.
(2) Take out the push switch from the CD mechanism assem-
bly.
Reference:
Remove the wires from soldered sections b of the push switch
as required.
3.1.3 Removing the base board
(See Figs.3 and 4)
Caution:
Solder the short land c before the flexible wire is disconnected
from the connector on the pickup. If the flexible wire is discon-
nected without applying solder, the pickup may be destroyed
by static electricity. (See Fig.3.)
(1) From the bottom side of the CD mechanism assembly, re-
move the screw C attaching the base board. (See Figs.3
and 4.)
(2) Solder the short land c on the pickup. (See Fig.3.)
(3) Disconnect the flexible wire from the connector on the pick-
up. (See Fig.3.)
(4) Remove the base board from the joints d of the frame in the
direction of the arrow. (See Figs.3 and 4.)
Reference:
Remove the wires from the soldered sections e on the base
board as required. (See Fig.3.)
Caution:
When reattaching the base board, be sure to remove solder
from the short land c after connecting the flexible wire. (See
Fig.3.)
Pickup
B
Wires
Push switch
b
e
C
Base board
CD mechanism
Frame
assembly
d
Flexible wire
Pickup
c
Connector
Fig.3
C
Base board
Flexible wire
Frame
d
Fig.4
(No.MY008)1-7

Advertisement

loading