Advertisement
remote sensor.
MODE button on the inside of the remote sensor allows you to see the humidity and the
temperature. When you press the button once it will show the humidity when pressed again it
will show an arrow and that will scroll from temperature and humidity. When pressed again
than it will stay on temperature.
When replacing batteries for the remote sensor, remember to clear the corresponding
channel of the home unit in this way: Select the respective channel by pressing the
CHANNEL button then by holding the CHANNEL button for 3 seconds to clear the
registration.
Note: The "TX" and the "C/F" are hidden inside the protective backing to ensure weather resistance of this unit
that is intended for the outdoors. The remote sensors are not "waterproof" meaning able to submerse, but
rather water resistant or weather resistant. Prolonged exposure to cold weather may cause damage to the LCD
panel and in addition can drain your batteries. Extreme heat can cause your batteries to drain and more
importantly, explode and corrode in the compartment. Battery corrosion will harm the unit. Although these
units are intended for outdoor use, placing them in a protected area will preserve the life of the unit.
Celcius/Fahrenheit SELECTION on Main Unit and Remote Sensor
Press "– " to select C/ F. For remote sensor, press the "C/F" button inside the battery
compartment to select C or F.
How to Change the Time Zone
Press and hold the "-" button for 3 seconds the letter P will appear where the seconds are than
press and release the "-" button until the correct letter for your time zone appears. The four time
zones are P is Pacific, M is Mountain, C is Central and E is Eastern Time zone. Press the SET
button to confirm or leave the setting to confirm and exit automatically.
RADIO-CONTROLLED CLOCK
The unit will start synchronizing the clock after the 1
registered. Press set button for force synchronization. The antenna icon will appear during
synchronization, if the icon disappears afterwards this is indicating that the radio time signal is not
available at present moment. If you are unable to obtain a signal after a small period of time,
place the unit away from source of interference such as mobile phones, appliances etc.
The radio-controlled clock will have a daily synchronization at 01:00 everyday. Each reception
cycle is a minimum of 2.5 minutes and a maximum 5 minutes.
MOON PHASE
The moon phase will be displayed automatically according to current calendar. The moon phase
is shown by the scrolling of the moon icon from left to right. The moon icon will stop at the
existing moon for 5 seconds and than resume scrolling.
SETTING UP THE BAROMETER
When the power is up, the pressure section will display 1013 for 60 seconds. Press P+, P- to
adjust the air pressure according the current sea level pressure value (please see
http://weather.unisys.com/surface/sfc_con_pres.html
level measurements). To change the scale between mb and inHg, hold P- for 3 seconds. To
adjust the temperature and humidity based on sea level, hold the PRESSURE key for 3 seconds,
press P+, P- to adjust, press PRESSURE to confirm. There is no need to enter the existing
weather into the unit as the digital barometer will calculate and forecast the weather conditions
based on the air pressure data.
Quick guide to help you adjust the air pressure according to sea level:
1. Hold "PRESSURE" key 3 seconds
st
channel of the RF thermometer is
in order to help set and adjust your sea
Advertisement
