Important Safety Instructions - JBL SDP-75 User Manual

IMPORTANT SAFETY
•
Read the following instructions carefully. Save all instructions for future reference.
•
Follow all warnings and instructions.
•
JBL Synthesis expressly forbids unauthorized modification of this equipment.
•
Using the unit in the following locations can result in a malfunction:
In direct sunlight
o
Locations of extreme temperature or humidity
o
Excessively dusty or dirty locations
o
Locations of excessive vibration
o
Close to magnetic fields
o
•
Condensation can form on the inside of the apparatus if it is suddenly moved from a cold environment to a
warmer location. Before switching the unit on, it is recommended that the unit be allowed to reach room
temperature.
•
Install the SDP-75 on a solid, flat, level surface that is dry, well ventilated and out of direct sunlight. Be sure
that all four feet are supported.
•
• Clean only with a dry cloth. Do not use liquid solvent-based cleaners.
•
Protect the detachable power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus. If the ac cord becomes damaged, do not use it.
Immediately replace it with a new one of the same or better rating.
•
Unplug this apparatus during lightning storms or when unused for long periods of time.
•
Do not open the equipment case or remove any of the cover panels. There are no user serviceable parts in this
equipment. Refer all servicing to qualified service personnel;
•
To prevent fire or shock hazard, do not allow liquids to spill or objects to fall into any openings of the product.
•
Always insert the ac plug into a grounded outlet. Do not remove the ground pin or disable the ground for any
purpose. The main AC has to be protected by a circuit breaker conforming to local standards.
•
Before connecting the equipment, check that the main power supply voltage rating corresponds with the local
main power supply. The rating of the main power supply voltage is printed on the equipment.
•
If replacement of the ac line fuse and/or any internal fuse becomes necessary, replace only with same value
and type of fuse (110V: T1A Schurter FST 5x20; 220V: T800mA Schurter FST 5x20). Never bypass the fuse.
•
It is imperative that the SDP-75 be operated in a well ventilated environment and the immediate external
temperature be maintained as specified. Do not expose the SDP-75 to humidity, steam, smoke or excessive
dampness or dust. Maximum permissible operating conditions: 0°C to 40°C, 20-65% relative humidity. External
cooling fans may be required in some cases.
•
Do not stack any equipment directly above or below the SDP-75 as to protect it from overheating, as well as
the continued functionality of any equipment near and around it.
•
Do not ingest the remote control battery. The remote control supplied with this product contains a coin battery.
If the button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely, stop
using the product and keep it away from children. If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.
TO COMPLETELY DISCONNECT THIS APPARATUS FROM THE AC MAINS, DISCONNECT THE POWER SUPPLY
CORD PLUG FROM THE AC RECEPTACLE.
THIS SYMBOL IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS
VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK.
INSTRUCTIONS
5