Advertisement
Retrig: Retriggers the osc to start at the point specified by the phase knob with each new midi
gate.
Invert: Inverts the shape of the Saw/Tri output.
Mod Gen Patch Outputs:
-
Three LFO shape outputs: Saw/Tri, Pulse, Mix. The mixed output presents a mix of the
saw/tri output with the pulse output.
Amp: When turned on the device bypasses the vca section and is always outputting sound.
Note: When turned off the device responds to midi note messages and uses them as the base
pitch of the device. When turned on the device does not respond to midi notes but instead uses
the value set in the note select knob as the base pitch of the device.
Note Select: The base note used for the pitch of the device when note mode is turned on.
Drone Mode Patch Output: Outputs the note selected in the note select as frequency
information (for example to provide the drone note to another modular oscillator).
Amp: Allows for added gain to the incoming signal.
Distort: Distortion of the incoming signal.
LP Cut: Cutoff point of a lowpass filter applied to the incoming signal.
HP Cut: Cutoff point of a highpass filter applied to the incoming signal.
Follower Attack: Attack parameter for the enveloper follower derived from the incoming audio.
Follower Release: Release parameter for the enveloper follower derived from the incoming
audio.
Main Volume: Master volume of the synthesizer section which goes to the synth output (but
before the effects chain).
Volume Mod: Volume modulation (tremolo) depth applied to the main volume via an external
modulation signal connected to the input.
Warm: Switch for turning on a mild distortion effect.
Soft: Switch for turning on a mild soft saturation / soft clip effect.
FX Chain Input Crossfade: Crossfade between the hard wired effects chain input (the sound
coming from the synth output section) and the fx chain's external input. Note that if you are
outputting the internal synthesis from the fx section, the voices are summed within the device and
you do not need a poly out module, since after the effects the device is monophonic.
FX Bypass: Turns on the signal passing through the effect. Note that if an effect is not loaded in
the slot and the slot is turned on, there will be no sound passing through the slot.
Drone Mode
External Processing
Output Section
FX Chain
Patch Effects
Advertisement
