Advertisement
Code Identification
1. Press and hold the P (Program) button until the
red indicator stays lit. Release the P (Program)
button.
2. Press and release the desired mode button (TV,
VCR, etc.). The red indicator blinks, then stays
lit.
3. Press and release the P (Program) button. The
indicator light blinks off.
4. To find the first digit for the code stored under
the mode key you pressed in step 2, press each
numeric key from 0-9 in turn. When the indica-
tor blinks off, the number you pressed is the
first digit for the code you are searching for.
5. Repeat step 4 to find the second and third digits.
(Indicator goes off when third digit is found).
Sleep Function
The Sleep button accesses the sleep function of
your TV if it has that feature. If it doesn't you can
enable the remote to turn off your TV after a
period of 1 to 99 minutes as shown below. The
remote must be in TV mode to set a Sleep Timer.
This feature works even if your TV does not have a
sleep feature.
1. Press and release the TV mode button.
2. Press and hold the Sleep button until the LED
remains lit (about 2-3 seconds).
3. Release the Sleep button.
4. Press and release the numeric buttons (01-99)
for the time required. The LED will blink off to
indicate button press acceptance.
5. TV Sleep Timer is set.
6. Leave the Remote pointing towards the TV
with an unobstructed path.
To cancel the Sleep Timer, press and hold the
Sleep button until the LED blinks, or press and
release the Power button in TV mode.
8
Operation
1. Press the mode button for the desired device.
2. Aim the remote at the device.
3. Press POWER to turn on the device.
4. Press other buttons to operate the features of
your device.
Note: The REC button must be pressed twice to
record from your VCR. For some brands of VCRs,
you might need to press the REC button once, then
press it again for three seconds.
Troubleshooting
Remote does not operate your device.
• Press the mode button of the device you want
to control.
• Program the remote with a new code.
• Install new batteries. (You might have to
reprogram your remote after installing new
batteries.)
• Remote may not be compatible with your
device.
Remote does not operate some features of your
device.
• Program remote with a new code.
• Remote may not be able to operate all features
of your device or button names might be
different than your device.
Indicator light blinks after you program a
device code.
• Remote did not accept the code.
• Try to program the code again or try a different
code.
9
Hide quick links:
Advertisement
