JVC KS-FX230 Service Manual page 7

Removing the loading motor ass'y
1. Remove the head relay ass'y.
2. Remove the load arm ass'y.
3. Remove the Mylar washer h fixing the worm gear.
NOTE : When reassembling, be sure to use a new
mylar washer.
4. Remove the screw H fixing the loading motor ass'y.
5. Remove the two screws I fixing the loading motor
ass'y. (see Fig 11)
(Procedures for reassembling)
1. Insert the mode gear into the sub chassis ass'y.
2. Install the sub chassis ass'y and secure it with the
two screws C and D as shown in Fig.12.
NOTE : The set arm ass'y and the mode gear
should be positioned as shown in Fig.12.
3. Attach the cassette holder as shown in Fig.13. In this
case, first pass the tab of the section i through the
mechanism j, then attach the cassette holder in the
direction shown by the arrow.
(see Fig. 11)
(see Fig.11)
(see Fig.11)
Sub chassis ass'y
Loading motor ass'y
H
Fig.11
C
Sub chassis ass'y
Mode gear
Fig.12
Cassette holder
Fig.13
KS-FX230
h
Worm gear
Motor bracket
I
D
Set arm ass'y
i
j
1-7