Advertisement
Ademco
K9230V3
5820L Interior of box
File: K9230V3_Blueline_Ademco_5820L_instruct_interior.eps
See inside of
carton for
installation
instructions.
5820L is a single-zone Slim-Line
Door/Window contact transmitter
that provides wireless notification
of intrusion.
NOTE
During the programming of the
control panel transmitter must be
enrolled as Input Type 3,
Supervised RF), Loop 1.
Installation
1.
Temporarily mount the 5820L
and magnet using the double-
back tape provided.
NOTE
Before mounting permanently
using the double-back tape or
mounting screws, conduct a
Go/No Go test to verify adequate
signal strength and reorient or
relocate the transmitter if necessary
2.
If the Go/No Go test was
successful, remove the
transmitters cover by inserting
the flat blade of a small screw-
driver into the opening slot at
one end of the unit as shown
in the diagram and separate the
two halves.
3.
The 5820L must only be
mounted against a flat surface.
A curved surface would cause
undo stress to the unit and
possible failure to operate
properly.
4.
Install mounting screws
MAGNET ALIGNMENT
in the two outside
mounting holes as
shown in the diagram
using a #1 Phillips.
MAGNET
5.
If the case-back tamper
switch will be used,
install a third screw in
the middle hole.
6.
Mount the magnet
(supplied) adjacent to
the two vertical
positioning lines on the
case side (see diagram).
The gap can be one-half
of an inch maximum.
7.
To reinstall the cover,
position the cover so
that it covers the
mounted case-back, and
snap-shut. The two case
halves can only be fitted
together in one direction.
NOTE
Do NOT attempt to remove
the PCB from the plastic
cover for any reason.
BATTERY CAUTION: Risk of fire,
explosion and burns. Do not
recharge, disassemble, heat above
212 F (100 C) or incinerate.
Dispose of used batteries properly.
Keep away from children.
Battery Information
Replace battery only with:
Energizer L92 AAA Lithium or
AAA Alkaline, Duracell MX2400,
Panasonic AM-4PI,
Eveready Engeriger EN92.
Observe correct polarity.
NOTE
Alkaline Battery Will Yield Less
Battery Life than Lithium
REFER TO THE INSTALLATION
INSTRUCTIONS FOR THE CONTROL
WITH WHICH THIS DEVICE IS USED,
FOR DETAILS REGARDING
LIMITATIONS OF THE ENTIRE
ALARM SYSTEM.
LOCATORS
GAP
OPENING
0.5" MAX
SLOT
FCC / IC Statement:
This device complies with Part 15
of the FCC Rules, and RSS 210 of
IC. Operation is subject to the
following two conditions: (1) This
device may not cause harmful
interference (2) This device must
accept any interference received,
including interference that may
cause undesired operation.
Cet appareil est conforme à la
partie 15 des règles de la FCC &
de RSS 210 des Industries
Canada. Son fonctionnement est
soumis aux conditions suivantes:
(1) Cet appareil ne doit pas causer
d' interferences nuisibles. (2) Cet
appareil doit accepter toute
interference reçue y compris les
interferences causant une
reception indésirable.
Advertisement
