3. Setup Wizard
After you login the configuration utility, you can click "Setup Wizard" on the upper left of the page
to start setting up BLW-54CW3. You can finish setting up the router and begin to connect Internet
just through a few simple and easy steps. Please follow the instructions below to set up
BLW-54CW3.
3.1 Operation Mode
Setup different modes to LAN and WLAN interface for NAT and bridging function. There are two
modes that can be chosen: Gateway and Bridge.
Gateway: In the Gateway mode, BLW-54CW3 is supposed to connect to internet via
ADSL/Cable Modem. NAT is enabled and PCs in four LAN ports share the same IP to ISP
through WAN port. The connection type can be setup in WAN page by using PPPOE, DHCP client,
PPTP client or static IP.
Bridge: In the Bridge mode, all Ethernet ports and wireless interface are bridged together and
NAT function is disabled. All the WAN related function and firewall are not supported.
Cancel: If you do not want to configure this setting right now, click this button to exist this
page.
Back: Go back to the previous configuration page.
Next: Proceed to the next configuration page.