Table of Contents
Advertisement
PEDAL SHA FT I NSPECTION
REDAL SHA FT
I NS P E CT I ON
•
Check the condition of deformation of
pedal shaft and sprocket.
•
Check the condition of Needle Bearing.
Apply grease to the needle bearing and
washers when assembling.
CHAN G E LEVE R
I NSPECTION
111
Check the condition o f 0-RlNG.
the
11
Check
DEFECT condition of push
plate.
*
If push plate is bent. replace it.
*
When assembling the change lever apply
grease to 0-Ring.
7 - 5
1 ) Shaft, Starter Pedal
2) Housing Comp., Start Needle Bearing
3) Washer, Trust (20MM)
4)
Sprocket, Start (30T)
x
5) Bolt, HEX. (5
12)
6) Washer, Thrust (16MM)
7) ARM, Crank Axle RH.
8)
ARM, Crank Axle LH.
9) Washer,
(6MM)
10) Nut, Cap (6MMJ
1 1 J Pin, Crank Arm
12) Pedal Ass'y., Crank RH.
13) Pedal Ass'y., Crank LH.
Hide quick links:
Advertisement
Table of Contents
