Disassembly Procedure - JVC TM-H1700G/E Service Manual

TM-H1700G
SPECIFIC SERVICE INSTRUCTIONS

DISASSEMBLY PROCEDURE

CAUTION
Even with the power switch turn off, some parts of in this unit are
live. Be sure to disconnect the power plug from the AC outlet
before disassembly and reassembly.
REMOVING THE TOP COVER
1. As shown in Fig.3, remove the
2. Slightly spread the bottom of the top cover.
3. Shift the cover rearward and raise it upward to remove it.
REMOVING THE REAR PANEL
After removing the top cover.
8
1. Remove the screws marked
2. Remove the screw marked
3. Remove the screw maarked
the terminal bracket.
5
4. Remove the screws marked
terminal bracket.
5. Remove the screw marked
the chassis base.
2
6. Remove the hexagonal screws marked
terminal with the terminal bracket.
7. As shown in Fig.1, lift the rear panel and remove the claw marked
from the terminal bracket.
8. Shift the top portion of the rear panel slightly rearward and raise it
upward to remove it.
REMOVING THE TERMINAL BRACKET
Remove the top cover and rear panel.
1. Pull the PW connector out from the MAIN PWB, connected
betweeen the main power switch and MAIN PWB.
2. As shown in Fig.2, raise the claw marked
side of the chassis base, and lift the terminal bracket from the
chassis base.
3. Slightly shift the terminal bracket rearward and raise it upward to
remove it.
6
8
screws marked .
.
attached the FBT.
attached the SIGNAL PWB with
attached the terminals with the
attached the terminal bracket with
attached the D-SUB
positioned back
TERMINAL BRACKET
TERMINAL BRACKET
No.51922
REAR PANEL
Fig.1
CHASSIS BASE
J
MAIN PWB
Fig.2
H