Antenna Information - Titan TR200 User Manual

Battery Information
Please follow steps below to charge the radio/battery with a desktop
charger:
1. Plug the AC connector of the switching power into an AC outlet socket.
2. Plug the Mini USB connector of the switching power into the Mini USB port
on back of the desktop charger.
3. Place the radio with the battery attached, or the battery alone, into the
charger.
4. Make sure that the battery is in good contact with charging pieces of the
desktop charger. The charging process begins when the charger LED glows
orange.
5. When charging is completed, the charger LED glows green. Then you may
remove the radio or battery.
Status Charger LED
Charging Solidly glows orange
Fully charged Solidly glows green
You can also use the approved Six-Unit Switching Power to charge up to six
radios/batteries simultaneously, as shown in Figure 1. Please refer to the
Owner¡¯ s Manual for Six-Unit Switching Power for detailed operation procedures.
9
８１１００３１０１００１０－－ＴＣ－３１０ Ｅｎｇｌｉｓｈ ＴＲ ＬＯＧＯ ｕｅｓｅｒ ｍａｎｕａｌ ０１ （ＲｏＨＳ）．ｐ６５ Page 10-11
Battery Information
Figure 1 Schematic Diagram of Six-Unit Charger
When multiple desktop chargers are used simultaneously, you may connect the
chargers in parallel to create a multi-unit charger.
Assembly Method: Slide the latch of a charger into the slot on the bottom of
another charger, as shown in Figure 2.
Figure 2
Diagram of Multi-Unit Charger Assembly

Antenna Information

Stubby antenna is durable and ideal for communication at low transmit
power.
Communication range may vary with terrain and your operating conditions.
Rainy days or forest locations may narrow your communication range, so
please make full preparations in advance to avoid potential inconvenience.
10
2011-3-24, 13:44 Ａｄｏｂｅ ＰａｇｅＭａｋｅｒ ６．５Ｃ／Ｗｉｎ