Battery Information - Titan TR200 User Manual

Radio Overview
PTT (Push-to-Talk) Key
Press and hold down the PTT key to transmit, and release it to receive.
Programmable Function Key
The side key can be programmed with long/short press functions by your
dealer.
Note: Short Press means key press shorter than 1 second, while Long
Press means key press longer than 1 second.
LED Indicator
Status indications and alert tones are shown in the table below:
Power On (to When the radio is turned on, an alert tone sounds and the
enter User Status Indicator flashes orange once.
Mode) When the radio is currently on a blank channel, it sounds
beep tones continuously.
Power Off When the radio is turned off, the power-off alert tone is
heard.
Low Battery Alert The Status Indicator flashes red, and a low-pitched tone
sounds at an interval of 10 seconds.
The Status Indicator glows red.
Transmitting When TOT timer expires, the radio sounds beep tones
continuously.
A TOT pre-alert tone sounds before the TOT timer expires.
Receiving The Status Indicator glows green when carrier is present.
The Status Indicator flashes green once per second,
Scanning while scanning is in process.
Scan Start Alert (programmable by the dealer): one beep
is heard.
When signals are received on a certain channel, the
Status Indicator solidly glows green.
Scan End Alert (programmable by the dealer): one beep
is heard.
5
８１１００３１０１００１０－－ＴＣ－３１０ Ｅｎｇｌｉｓｈ ＴＲ ＬＯＧＯ ｕｅｓｅｒ ｍａｎｕａｌ ０１ （ＲｏＨＳ）．ｐ６５ Page 6-7
Radio Overview
A low-pitched tone is heard when the radio switches
Power Adjustment from high power to low power.
A high-pitched tone is heard when the radio switches
from low power to high power.
VOX
Compandor One beep sounds when the feature is enabled.
Scrambler Two beeps sound when the feature is disabled.
Channel Lock
Battery Latch
Used to secure or remove the battery.
Audio Accessory Jack
Used to connect audio accessories.
Mini USB Port
Used to connect accessories such as programming cable, cloning cable and
switching power.

Battery Information

Initial Use
New batteries from the factory are not fully charged, so be sure to charge a new
battery for at least 5 hours before initial use. Three full charge-discharge cycles
would optimize the capacity and performance of your battery. When battery
power runs low, it is time to recharge or to replace the battery.
Applicable Battery Packs
Please only use the battery specified by the manufacturer. Other batteries may
burst, causing bodily injury and property damage.
Caution:
1. Do not dispose of the battery in fire!
2. Recycling and disposal of the battery shall comply with your local regulations.
3. Never attempt to dismantle the battery.
6
2011-3-24, 13:44 Ａｄｏｂｅ ＰａｇｅＭａｋｅｒ ６．５Ｃ／Ｗｉｎ