Monitor; Scan - Titan TR200 User Manual

Advanced Operations
There is no indication upon press of the programmed
Battery Strength Indication key. However, the indi
Less than 10% cator keeps flashing red in standby status and keeps
sound ing a low-pitched tone at an interval of 10 seconds.
If you press PTT at this time, the radio will sound an
alarm sound to warn you of the transmission inhibition.

Monitor

Squelch Off
Purpose: In this mode, the speaker is unmuted in any condition so as to receive
any sound on the current channel. When audio signal is received on the channel,
audio will be heard. Otherwise, background noise will be heard.
Operation: Press the Squelch Off key to enter this mode, and press it again to
exit.
Squelch Off Momentary
Purpose: Refer to Squelch Off.
Operation: Hold down the Squelch Off Momentary key to enter this mode, and
release the key to exit.
Monitor
Purpose: In this mode, the receiving party can receive incoming calls regard-
less of CTCSS/CDCSS condition. If the carrier condition is not satisfied, the
receiving party will fail to receive any incoming calls.
Operation: Press the Monitor key to enter this mode, and press it again to exit.
Monitor Momentary
Purpose: Refer to Monitor.
Operation: Hold down the Monitor Momentary key continuously to enter this
mode, and release the key to exit.

Scan

The Scan feature enables a two-way radio to continuously scan each channel
for activity. Press the key programmed as Scan, scan starts from the current
17
８１１００３１０１００１０－－ＴＣ－３１０ Ｅｎｇｌｉｓｈ ＴＲ ＬＯＧＯ ｕｅｓｅｒ ｍａｎｕａｌ ０１ （ＲｏＨＳ）．ｐ６５ Page 18-19
Advanced Operations
channel and ascends through the channel numbers in scan list. The Status
Indicator flashes green during scanning. When signals are received on a certain
channel with signaling matches, the Status Indicator solidly glows green. To exit
Scan mode, press this key again.
When Scan feature is activated, the radio begins continuous scanning for
activity on channels that can be scanned. If any activity is detected, the radio
will switch the channel to receive the call (the channel that can be scanned are
programmed by your dealer).
No Priority Channel
Suppose there is a scan list of 6 channels and all channels are non-prioritized,
the normal scan operation may proceed in the following sequence, as shown in
Figure 1.
Priority Channel Scan
Suppose there is a scan list of 5 channels and Channel 2 is prioritized as Priority
1, the scan operation may proceed in the following sequence, as shown in Figure
2.
Figure 1 Figure 2
Normal Scan Sequence
Scan On/Off
You can enter Scan mode through any of the following two methods:
1. Key-operated Entry
Press the programmed Scan key to enter Scan mode, provided that there are no
18
2011-3-24, 13:44 Ａｄｏｂｅ ＰａｇｅＭａｋｅｒ ６．５Ｃ／Ｗｉｎ
Priority Scan Sequence