8. How to wind up the Mainspring
The Mainspring can be fully wound either by hand or with Screwdriver.
・Manual winding ...Turn the crown clockwise at least 55 times (equal to 8 turns of the Ratchet wheel screw)
・Screwdriver winding ... Turn the Ratchet wheel screw 8 times clockwise.
[ Manual winding ]
9. How to Install hands
Place the movement on a flat metal plate or something similar.
We recommen using "Universal Movement Holder" S-682.
Be careful not to apply strong pressure to the movement.
<<Note: Power reserve hand setting>>
(1)The Mainspring should be fully wound up before installing power reserve hand.
(2)Set Power reserve hand at "F" position on the Indicator
[ HOW TO CHECK ]
TECHNICAL GUIDE
・Fully wound status
Auxiliary main plate pin
Enlarged
view
・Not fully wound status
[ Screwdriver winding ]
Screwdriver
Ratchet wheel screw
Intermediate power
reserve wheel
13/14
Cal.4R57A
Ratchet wheel
Metal plate
[ Hand setting position ]
Setting position
of power
reserve hand