Preparing To Install The Refrigerator - Magic Chef MCSR-6085W Instruction Manual

Installation Instructions

Preparing to install the refrigerator.

Read these instructions completely and carefully.
Refrigerator Location
•
Do not install the refrigerator where the temperature will go below 50°F (10°C)
because it will not run often enough to maintain proper temperatures.
•
Install it on a floor strong enough to support it fully loaded.
•
Do not install it closer than 5"(13 cm) next to a range.
•
Do not install it in a recessed area.
•
Do not build in the refrigerator.
Clearances
Allow the following clearances for ease of installation and proper
air circulation.
Sides 113) "2/ mm)
Top 2" (51 mm)
Back 2" (51 mm)*
*From the rear cabinet surface to the wall
Leveling Legs (on some models)
Adjustable legs at the front corners of the refrigerator should be set so the refrigerator
is firmly positioned on the floor and the front is raised just enough that the door
closes easily when opened about halfway. To adjust the leveling legs, turn the legs
counterclockwise to lower the refrigerator, clockwise toraise it.
8
Preparing to install the refrigerator.
Door Reversal
1. Remove the two screws from under the screw caps located on the top cover.
2. Remove the two screws from the back of the top cover and remove top cover.
3. Remove the top hinge by removing the two screws, as shown.
4. Remove the freezer door by lifting off of the middle hinge.
5. Remove the J-shaped hinge support on the bottom of the freezer door.
6. Install new J-shaped hinge support on the opposite side of the freezer door bottom.
The new J-shaped hinge support and mounting screw are located in a zip lock bag that
is shipped with the refrigerator.