Download Print this page

Adidas ADBE-10234 Assembly Instructions Manual

Utility bench

ADBE-10234 UTILITY BENCH

ASSEMBLY INSTRUCTONS

Table of Contents

Need help?

Do you have a question about the ADBE-10234 and is the answer not in the manual?

Page 1 ADBE-10234 UTILITY BENCH ASSEMBLY INSTRUCTONS...
Page 2 PARTS CHECK LIST...
Page 3 HARDWARE PACK CHECK LIST...
Page 4 EXPLODED DIAGRAM...
Page 5: Parts List
PARTS LIST DESCRIPTION DESCRIPTION CENTRAL BRACE HEX BOLT M10*75MM FRONT LEG FOAM TUBE BACK ADJUSTMENT SLIDER ROUND PLUG (25.4MM) SQUARE BUSHING 60MM HEX BOLT M12*65MM HEX NUT M10*8MM HEX BOLT M10*70MM BACKREST SUPPORT WASHER M10*25MM BACKREST BRACE HEX NUT M10*12MM BACKREST HEX BOLT(M8*40MM) SEAT PAD...
Page 6 **PLEASE DO NOT FULLY TIGHTEN UNTIL THE ASSEMBLY IS COMPLETE** STEP1 ATTACH FRONT FOOT TUBE (2) ONTO CENTRAL BRACE (1) AND SECURE WITH 2 HEX BOLT M10*75MM (14), 2 WASHER 10*25MM (21) AND 2 HEX NUT M10 X 12MM (22). INSTALL BACK ADJUSTMENT SLIDER (3) THROUGH THE END OF CENTRAL BRACE (1) AND SECURE WITH LOCKING KNOB (24).
Page 7 STEP2 FIT THE BACKREST BRACE (7) ONTO BACK ADJUSTMENT SLIDER (3) AND SECURE WITH HEX BOLT M10*70MM (20), WASHER M10*25MM (21) AND HEX NUT M10*8MM (5). FIT THE MIDDLE HOLE OF BACKREST SUPPORT (6) ONTO THE END OF BACKREST BRACE (7), AT THE SAME TIME ALSO FIT THE END HOLE OF BACKREST SUPPORT (6) ONTO TOP SHAFT OF CENTRAL BRACE (1) AND HOLD THEM.