Table of Contents
Advertisement
Make sure the Caller ID service is turned on by your phone company.
When receiving an external call, the handset and the Base will ring. The "EXT' icon and the
MSG (MESSAGE) LED will flash.
Base In-use LED will flash according to the ring cadence.
EXT
The caller's number or name will be shown.
1.
Pick up the handset and press [
Note: i. If auto-answer function is enabled, the line can also be automatically
connected after the handset is lifted up from base.
ii. For preventing accidental line disconnection, users cannot press [
on-hook within 3 seconds after the handset is lifted up. To avoid handset dropping
from hand, handset will not go to on-hook when placing handset onto cradle within 3
seconds too.
2. Press [MENU/ ] or [ /
3. To end a call, simply return the handset to the cradle or press [
4. If a call with CID information remained unanswered after the call is gone for 3 seconds, the
handset and base will go back to standby mode. The CID icon
of unread caller ID number will be shown.
Notes:
i. Your unit has the memory capacity to store and display up to 20 call messages. When
the memory is full and new calls are received, earlier message will be replaced by the
new calls.
ii. When you receive the first call, the unit will automatically set the correct time and date.
iii. Calls pick up on the first ring will not be logged in the Caller ID Log.
RECEIVING A CALL
] to answer the call.
] to adjust the sound level from the earpiece if desired.
20
] to go
] again.
will be on and the number
Advertisement
Table of Contents
