Table of Contents
Advertisement
Changing Flash Time
The flash time can be changed so that the base can be compatible to different PABX system.
1.
Choose 'FLASH' from the BASE setting menu and the current setting is displayed.
3 0 0
Three different flash times can be selected (100ms, 300ms or 600ms)
2.
To select the desired flash time, press [MENU/ ] or [ /
3.
Press [INT/OK] to confirm the selection.
Reset Base Default Setting
Similar to the resetting procedure for the Handset, confirmation will be required.
Once confirmed, all the base setting parameters will be reset to factory setting.
Storing Number into the Phone Book
1. Choose 'STORE' under PHONE BOOK from the MENU to create a new phone book entry.
2. After selection, you will be prompted to enter the name first.
N A M E :
3. After the first pressing, the entering display will appear and the letter will blink once for 1
second, during this 1 second, the character can be entered by pressing a digit '1' to '0' for
different times within 1 seconds.
4. After one second whether no key or another digit key is pressed, the cursor will be advanced
by one step as shown, and blink to indicate the current entering position.
P _
5.
Press [C] to delete the current alphabet entry or press [INT/OK] to complete the name
entering procedure.
6.
You may enter a name of up to 10 characters. When entering the name, press [C] to clear
the last input character. Press [INT/OK] to confirm the name entered. If no character is
entered but press [INT/OK] to confirm, a warning tone will prompt.
Note: Name and number cannot be empty.
].
15
Advertisement
Table of Contents
