Troubleshooting Setup - Tank Utility Cellular Tank Level Monitor Setup Manual

Troubleshooting Setup

When the monitor is prompted to send a reading each LED will blink in succession.
Each LED will turn aqua blue when the corresponding step is completed. If a problem is
encountered, the LED will turn red.
BATTERY VOLTAGE CELL SIGNAL STRENGTH READING CONFIRMATION
The monitor cannot connect The monitor has not
The batteries need
to the cellular network because received a confirmation
to be replaced.
the signal is not strong enough. of a successful reading.
To Turn Off The Tank Monitor
This will prevent the monitor from
sending additional readings. Hold the
activation magnet activation
over the
pad
for approximately 15 seconds until
all 3 LEDs are red. Remove the activation
magnet while all 3 LEDs are red.