Tank Utility Cellular Tank Level Monitor Setup Manual page 5

STEP 2: Turn Your Monitor On And Prompt A Reading
Hold the activation magnet (attached to the
activation pad
cable) to the (denoted by the
magnet icon) on the monitor for 3 seconds,
then remove when the 3 LEDs blink aqua blue.
This will turn the monitor on and send a
reading.
The LEDs will flash in succession as the
monitor attempts to send a reading. When
all 3 LEDs are solid aqua blue, a reading
Hold the magnet to the
was sent successfully.
activation pad.
It may take up to five minutes to
NOTE:
establish cellular connection.
Please refer to the "Troubleshooting"
section of this guide if your monitor
shows any red LEDs.
Successful reading confirmation
shown by 3 solid aqua blue LEDs.