Battery Replacement; Reception Of Radio Controlled Time Signal - Sharp SPC900 User Instructions

BATTERY REPLACEMENT

If the low battery indicator " " appears beside the outdoor
temperature of main unit, it indicates that you should replace
batteries of transmitter at once.
While if the low battery indicator displays beside the indoor
temperature, it means that the battery power of main unit is
not enough and you should replace batteries of clock
immediately.
Transmitter's low battery indicator
(shows on the main unit)
NOTE:
Attention! Please dispose of used unit or batteries in an
ecologically safe manner.
USING THE TABLE STAND OR WALL-MOUNTING STAND
The receiver and transmitter have both the desktop and
wall-mounting structures.
For the receiver, place the screw on the desired wall and
hang the receiver by the recessed hole in the back of it or
just simply place it on the desktop by its table stand.
14
Main unit's low battery indicator
(shows on the main unit)
OPERATING THE TRANSMITTER
1. Remove the transmitter from the stand and open the
battery door.
2. Insert 2 AA size batteries into the battery compartment
as per the polarity information marked on the battery
compartment.
3. Slide "CHANNEL" switch to synchronize the channel
with receiver.
4. Press "RESET" key individually by a pin to confirm the
channel setting.
5. Replace the battery door.
NOTE:
1. To receive the transmitter signal, the channels of
receiver and transmitter must be synchronized.
2. Once the channel is assigned to a transmitter, you can
only change it by removing the batteries or resetting
the unit.

RECEPTION OF RADIO CONTROLLED TIME SIGNAL

The time and calendar are radio-controlled. The current time
and calendar are automatically synchronized with the signal
transmitted from USA (WWVB).
When used for the first time (after inserting the batteries or
pressing "RESET" key), the clock will start to receive the
signals and the reception display will flash in 8 seconds.
7