Table of Contents
Advertisement
This connection differs from the one shown on page eight. You may still view any channel
(selecting channels at the Cable Box), but the instructions for playing a tape are different.
1. Connect a
Cable signal to the
VCP's ANT(enna)
IN Jack.
13.2V
Watching TV with the VCP Off
1
Turn off the VCP.
2
Turn on the TV and set it to the Cable Box output channel
(channel 3 or 4).
3
Turn on the Cable Box and select the channel you want to
watch at the Cable Box.
Playing a Tape
1
Make sure the Cable Box is on the same channel as the
VCP's CH3/CH4 switch.
2
Set the TV to the Cable Box output channel (channel 3 or 4).
3
Turn on the VCP or insert a tape, if necessary. Press the
PLAY button to play the tape. Details are on page 16.
2. Use an RF coaxial cable (supplied)
to connect the ANT(enna) OUT Jack
on the VCP to the IN Jack on the
Cable Box.
ANT IN
CH3
AUDIO
CH4
DC
OUTPUT
ANT OUT
VIDEO
Hookups With a Cable Box (cont'd) 9
IN
O UT
3. Use a second RF coaxial cable
to connect the OUT Jack on the
Cable Box to the ANTENNA IN
Jack on the back of the TV.
7 5
A N T
/
C A B
L E
TV ANTENNA
IN Jack
Advertisement
Table of Contents
