Setting The Controller To Operate A Dss Receiver - Philips/Magnavox VCR 462 Owner's Manual

46 Setting the Controller to Operate a DSS Receiver (cont'd)
6
Press the MENU button.
SELECT OUTPUT CH
OF YOUR DSS RECEIVER
0-
TO END PUSH EXIT
7
A zero will appear in the SELECT OUTPUT CH menu.
Press one Number button (3 or 4) to complete the out-
put channel of your DSS Receiver (channel 03 or 04).
• Press 0 if you connected the VIDEO/AUDIO OUT Jacks of the
DSS Receiver to the VCR's VIDEO/AUDIO IN Jacks. A/V will
appear on-screen as the output channel. A/V CONNECT A/V
REAR ONLY will appear.
• If you make a mistake, press the CLEAR button, then enter the
correct output channel.
SELECT OUTPUT CH
OF YOUR DSS RECEIVER
03
TO CONTINUE PUSH MENU
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
8
Press the MENU button.
9
A four will appear in the menu. Use the Number buttons
to enter the second digit of the two-digit code for your
DSS Receiver. (See the list on page 44.)
SELECT CODE NUMBER
OF YOUR DSS RECEIVER
42
TO TEST PUSH MENU
DID DSS RECEIVER
CHANGE TO CHANNEL 205?
1 YES 2 NO
TO END PUSH EXIT
10
Press the MENU button. Wait for the DSS Receiver to
change to channel 205. When it does, go to step 11.
• If the DSS Receiver does not change to channel 205, press the
Number 2 button to select NO. Repeat steps 9 - 10. If the DSS
Receiver doesn't change to channel 205, the Controller will not
operate your DSS Receiver. Press the EXIT/STATUS button.
11
Press the Number 1 button to select YES.
"DSS RECEIVER CONTROL IS ON" will appear for five seconds.
The screen will return to the program you were watching.
CBL/DSS VCR
EJECT POWER
VOL
F.ADV
PAUSE/STILL
PLAY
REW
VCR PLUS+
/ENTER
11
STOP
EXIT/STATUS MENU
7
1 2
4 5
9
7 8
100 0
REC /OTR
INDEX
...
VAR. SLOW
TRACKING
SPEED VCR/TV SLOW
REMOTE LOCATOR
Helpful Hints
• If your DSS Receiver does not
respond to the code in steps 9 - 10,
the Controller will not change chan-
nels at the DSS Receiver during a
timer recording. In this case, you
must select the channel to be
recorded at the DSS Receiver before
a timer recording begins. Leave the
DSS Receiver on for the timer
recording. Details are on page eight.
• If more than one code is listed for
your brand of DSS Receiver, try all
of the codes at steps 9-10 before
you determine the Controller will not
change the VCR Channels.
TV
MUTE
CHANNEL
FF
6
LIGHT
CLEAR
8
3
10
6
9
GO-TO
MEMORY
SKIP
SEARCH